KTI Networks Nway switch fiber 10/100, Fx Przewodnik Instalacji

-1-Installation Guide10/100 Fast Ethernet Switchwith 100FX ConnectivityKS-105F SeriesDOC.060302-KS105F

-10-The DC power jack for the AC power adapter is located on the rear of theswitch as shown below:2.3 Installing the Switch1. Install the switch with

-11-3. Making Network Connections3.1 Switched PortsThe following figure shows the locations of the switched ports:3.2 Making UTP Connections10/100 TP

-12-CablesDepending on the connection speed, use the proper UTP cables:Speed Cables used Distance100M Cat. 5, 5e, or higher grade 100 meters10M Cat. 3

-13-100FX Duplex SelectorThis selector is used for 100FX port duplex mode selection as follows:The following table lists the maximum MM fiber cable le

-14-4. LED Indicators4.1 LED PanelThe switch provides comprehensive LED indicators for diagnosing andmonitoring the operation of the switch as illustr

-2-(C) 2005 KTI Networks Inc. All rights reserved. No part of this documen-tation may be reproduced in any form or by any means or used to makeany dir

-3-The information contained in this document is subject to change withoutprior notice. Copyright (C) All Rights Reserved.TRADEMARKSEthernet is a regi

-4-Table of Contents1. Introduction ...51.1 Features...

-5-1. IntroductionThis 5-port Fast Ethernet switch series provides four 10/100 TP ports andone 100BASE-FX fiber port, each capable of transmitting or

-6-1.1 FeaturesDesigned for resolving congestion problems caused by bandwidth-hun-gry devices and bandwidth-intensive applications as well as a high n

-7-1.2 Specifications10/100 Ports IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX std.Shielded RJ-45 jacks with Auto MDI-X detectionAuto-negotiation capab

-8-100FX Port Fiber SpecificationsDuplex SeriesModel Fiber Wavelength Tx Power Sens. Ref.DistanceKS-105F-T ST MMF 1310nm -19 ~ -14dBm -31dBm 2kmKS-105

-9-2. Installing the Switch2.1 UnpackingCheck to see that you have everything before you start the installation.• Installation guide• The switch unit•