KTI Networks KS 2028 Instrukcja Użytkownika Pobierz pdf (Strona 14)

2.5 Setting the Configuration Switches

Open the configuration switch cover on the rear of the unit. There are

two switch groups as illustrated below:

Figure 2-9 Configuration Switches

The following table specifies the definition of each switch:

The M switch only functions for Port #9 and Port #10. Since Port #1 to

Port #8 are fixed 10BASE-T ports, the speed of these ports is fixed at

10Mbps. No speed selection is available. D1-D8 switches are used for

selecting the duplex mode for each 10BASE-T port respectively.

Port #9 and Port #10 can be configured as NWay auto-negotition ports if the M

switch is set to OFF position. This setting applies to both ports at the same time.

The auto-negotiation mode enables the port to negotiate a common op-

eration mode with the device connected at the remote end of the link

cable. The common operation mode is negotiated in the sequence as

follows:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Brak uwag

KTI Networks KS 2028 Instrukcja Użytkownika Strona 14